Mold Maintenance and Repair
Release time:
2024-03-29 15:04
Source:
(1) Purpose: so that the equipment can maintain the best performance status and extend the service life, to ensure the normal production.
(2) Scope of application: applicable to the repair and maintenance of molds.
(3) Regular inspection and maintenance: It is necessary to carry out regular maintenance and inspection by mold maintenance and mold up and down personnel.
(4) processed mold using electrolysis workers ultrasonic cleaning method to clean better. Cleaning at the same time play a role in rust prevention
1. Daily routine inspection and maintenance:
1.1 Is the running mold in a normal state
a. Whether there is a low-pressure mold locking protection; b. Active parts such as guide pillar, roof rod, line position whether wear and tear, whether the lubrication is good. Requirements for at least 12 hours to add oil, special structure to increase the number of times of refueling. c. The mold's fixed template screws and clamping clips whether loose;
1.2 Production of normal conditions:Check whether the defects of the product is related to the mold;
1.3 off the machine to carry out a comprehensive inspection of the mold and rust treatment: wipe dry cavities, cores, ejector mechanism and rows of parts such as water and spray mold antirust agent or grease.
1.4 The molds should be placed in the designated place after the machine is discharged and records should be made:
a. The condition of the mold: intact or to be repaired. b. The way of rust prevention treatment when the mold is discharged.
2. Routine inspection every quarter:
The main purpose is to clean and maintain the molds that have not been used for more than two months.
2.1 Open the molds and check the effect of internal rust prevention. If there is any abnormality, the molds should be treated with rust prevention again. The molds not used for a long time shall be coated with grease.
2.2 Put back to the original position and make a record.
Related News
1. the design of the mold product feasibility analysis, computer chassis as an example, first of all the components of the product drawings using the design software for the group analysis, that is, we work in the so-called set of drawings to ensure that the correctness of the product drawings before the mold design, on the other hand, you can be familiar with the components of the
Mold normal failure, the number of qualified products produced, called the mold normal life, referred to as mold life, the number of qualified products produced before the first repair of the mold, called the first life; mold a repair to the next repair the number of qualified products produced before the next repair,
Mold is the basic process equipment for mechanical industrial production, is the production of industrial products in the indispensable tools, mold steel made of the performance of the mold needs to be monitored through a strict production process, the production of raw materials for the mold must also undergo a rigorous check to prevent the mold due to material problems
(1) Purpose: so that the equipment can maintain the best performance status and extend the service life, to ensure the normal production. (2) Scope of application: applicable to the repair and maintenance of molds.
Injection and guide sleeve units
There are two types of mold guiding methods and accessories for guide injection and guide sleeve unit types: (A). External guide type (mold base type or called the main guide), (B). Inner guide type (or auxiliary guide). In order to meet the requirements of precision molds, there is a high demand for the use of both the outer guide and inner guide types.
High life mold form and mechanism
Mold in service, contact with the forming blank, resulting in relative motion. Because of the relative motion of the surface, the contact surface gradually lose material phenomenon called wear. Wear loss can be divided into the following categories: